glue starved or just couldn't take it anymore

This guitar came to us in two pieces. It’s the original neck joint and it came apart extremely cleanly. It almost looks as if not enough glue was used during the original assembly. With this type of break we first clean up the old glue, shim the side to side part of the joint (since that’s where most of the strength is required it needs to fit tightly) and then glue it up. This join will need no reinforcement since it is the original neck joint and fits together so well. Notice Tim’s trick of putting a clamp on in the middle of the neck to use as a place to attach a separate clamp that pulls the neck into the body. Before putting the neck on it’s also a good opportunity to check the neck angle to make sure the bridge will be the correct height off the body for desired action.

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *