RMC install in a Parker Guitar




The tricky part was getting the new pickups to fit and mount clean. We broke off the the legs of the pickups and mounted them into the wood with 2 of the pole-piece screws. The holes were enlarged to fit the larger and deeper pickups. The Rmc piezo loaded saddles are a little bit taller than the stock ones. We deepened the bridge route to keep the action low. The wiring harness we built up from scratch to keep all of the signals, piezo acoustic, neck mag, bridge mag and midi assembly separate. The pre-amp is the RMC Poly Drive 1.

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *